Monday, 23 May 2011

caliper mount mock up

Managed to get a 9mm conti board mock up made today. It lets me see what offset I need to do when i get my alloy and how it will look.

I got it made and when the wheel spins the disk has a slight high spot on the edge which is touching the caliper. I also noticed the pads are not quite far out enough and it presses on the inside disk area so another 2mm should clear that.

I will probably leave the fork holes alone till the rest of the mount is in place!

the pegs are there to ensure clearance and keeps the caliper in place

No comments:

Post a Comment